Genesys CCPulse – TotalTime vs TotalAdjustedTime

Have you ever seen 15 minute interval report in CCPulse or Datamart contains more than 900 seconds like below ?

Datamart Screenshot

In this case above, T_WAIT value is 937 seconds for 15 minute interval report, which is only 900 seconds. Strange isn’t it?

If you analyze configuration details, you will find that ‘T_WAIT’ uses ‘Total_Wait_Time’ statistics in out of box solution – which uses ‘TotalAdjustedTime’ category on subject ‘AgentStatus’ as below

totalwaittime

If you use ‘Total_Ready_Time’ which uses ‘TotalTime’, you will get actual time spent by agent on ‘wait status’ in reporting interval period.

TotalReadyTime

Below is brief explanation how this works..

Scenario : Agent ‘A’ was in Ready state from 14:55 to 15:05 i.e) 10 minutes and across two reporting intervals 14:45 – 15:00 and 15:00 – 15:15

In this case, ‘TotalTime’¬†and ‘TotalAdjustedTime’ will be calculated as below.

TotalTime

 

For more information about reporting categories, refer to Genesys documentation here

(Visited 27 times, 1 visits today)

Tagged: , ,

Leave a Reply

Your email address will not be published. Required fields are marked *